• Passivation Tank 6m x 2m x 2m
  • Electropolishing Tank 7m x 2.4m x 1.9m
  • Bead Blast Room 20m x 12m
  • Flat Bed Polisher up to 20mm thick
  • Tube Polisher up to 220mm diameter

Non-Mechanical Finishing

After Fabrication and Welding we use Expert Finishing techniques to improve the functional and the aesthetic qualities of the stainless steel.

Passivation is a non-electrolytic process and results in a finish that is contaminant-free surface and has enhanced corrosion resistance. Kent Stainless passivate by immersion in a 7m x 3m x 1.5m tank containing a diluted acid which dissolves surface contaminants. It cleans without brightening the surface.

Electropolishing uses an electrical current inside an acid bah to remove microscopic particles of contaminant and achieves a smoother finish and can remove heat tint and oxide scales. It is particularly suitable to the medical, pharmaceutical, and food sectors where super hygienic regimes are in place. Kent Stainless electropolish by immersing the products in a 7m x 2.4m x 1.9m bath containing temperature-controlled electrolyte and an electric current is applied – this results in the outer layer being dissolved

Mechanical Finishing

Our Bead Blasting Facilities are housed in a 20mx 12m dedicated blast room and we can apply blasting and peening allow over to large products up to 15m x 8m. Bead Blasting is particularly good to get a non-directional polished finish on products with complex geometries. It is also good for adding slip resistance to drain covers in barefoot areas

We also have a Flat Bed Polishing Machine, a Deburring machine, a Tube Polisher, and many manual hand polishing stations