Concentric Reducer Double Contained Section View

Concentric Reducer Double Contained P Bend

Double Contained Stainless Steel Drain with Removable O-Ring Top Plate and High Flow Rate

Flow-Optimized Drain with 6.1 L_s Capacity – KVCR265_4”RD

KVCR265_4”RD Drain with Suction Cup Removable Top Plate

loor Drain for Hazardous Fluids, High Flow, and GMP Compliance cover

Twin Wall BioWaste Floor Drain KVCRBWDC265/4”/6”RD

Overview
Features

The KVCRBWDC265/4”/6”RD Twin Wall BioWaste Floor Drain is a Dual Skin, Twin Walled or Double Contained version of our BioWaste Drain. It is designed to quickly fl ush down any biowaste through the drain body – ensuring there are no internal angles or internal foul air trap to slow the fl ow or act as areas of potential bacterial gathering.

Typical flow rates are 100 gallons per minute or 6 litres per second – but bespoke versions are available to take very high fl ow rates. This is a sealed cleanroom drain

with a strong positive seal created by machining away a 0.4” (10mm) groove from a 0.6” (15mm) top plate. A 0.4” (10mm) top plate with a recessed ‘o-ring’ creates the seal. This top plate is then removable with a heavy-duty suction cup available as an accessory. They are designed for use primarily in Pharmaceutical factories. They can be used in both light duty and very heavy-duty trafficked areas (sealed gullies are most often used in laboratories or cleanrooms which are limited to pedestrian traffic – however the 0.4” (10mm) top plate makes it possible to drive heavy factory traffic over these gullies). As standard the KVCRBWDC265/4”/6”RD takes a 0.4” (10mm) thick sealed grating but 0.4” (10mm) slotted and perforated gratings can also be used.

In most cases a dual 4”/6” or a dual 6”/8” SCH10 outlet is required because these are most popular with American Multinational Pharmaceutical companies who have scheduled stainless steel pipework to connect to, but this can easily be substituted for a 110mm/160mm or 160mm/220mm outlet pipe for European & other projects connecting with polypropylene pipework.

These drains are always supplied without the internal foul air trap – a P bend is available as an option.

Flow rate can be restricted by the slotted cover, the debris basket or the Cross Sectional Area (CSA) of the pipework. Use of a P-Trap reduces flow rate by approximately 15% due to geometry. The slotted cover reduces the flow rate from 6.3 to 6.1 L/s (97.8 US GPM). Flow rates are based on 2” (50mm) head of water above the top of the drain.